Replacement: None. There is no direct replacement for this board. This page is for reference only.

Prototype board for the LPC2106 processor.

• MCU: 16/32 bit** LPC2106**
• 128K Bytes Program Flash, 64K Bytes RAM, RTC, 2x UARTs, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
• 14.7456 MHz crystal divides down for easy communication setup
• Internal 4x PLL = 58.9824 MHz CPU clock
• JTAG connector as per ARM's 2x10 pin layout, ARM-JTAG (Wiggler) compatible
• RS232 interface circuit
• RESET circuit
• Push BUTTON with pull-up resistor
• Status LED
• Boot loader enable jumper and pull-up
• DBGSEL, RTCK pull-up resistors
• Two on board voltage regulators rated up to 800mA - 1.8V (Internal CPU) and 3.3V (General I/O)
• Prototype PCB area with +3.3V and GND bus
• Extension header for uC pins
• DC power jack - Center positive
• Single power supply: +5-9VDC required
• Power supply decoupling/filter capacitors
• PCB: FR-4, 1.5 mm (0.062"), green solder mask, white silkscreen component print
• Four mounting holes

• 3.9x3.05" (100x77mm)

• LPC-H40 Schematic