Categories
Resources
-
Feeds
- Education Department
- Forum
- SparkFun IRC Channel
- BatchPCB
- Open Circuits
- Ponoko - Your Personal Factory
- Jobs @ SparkFun
- Sell Your Widget on SparkFun
- Become a SparkFun Distributor
- Take the SparkFun Quiz
- Tell us about a project
Currency
Display prices in
US Dollar 
Canadian Dollar Feedback
Home Member Profile
:MattW:
Member Since:
March 26, 2010
Gender:
Male
Country:
United States
Bio:
Born and raised in Denver/Elizabeth, CO.
Organizations:
USAF
Spoken Languages:
English, Peanuts Adult, a bit of Spanish and a byte of German.
Programming Languages:
C/C++, Verilog (?), Java
Schools and Universities:
University of Colorado Denver
Interests or Hobbies:
Snowboarding, Soccer, Cycling, Climbing, Yoga, Electromagnetics, Antennas, Embedded Systems, Philosophy, Physics, Counter-Strike,
No public wish lists :(
Product DEV-09873 | about 2 years ago
EngGirl
As such?
XBee Explorer USB
http://www.sparkfun.com/products/8687
Product DEV-09115 | about 2 years ago
Help please. The FTDI chip’s datasheet says that pin 23 is TX LED and pin 22 is RX LED, by default. In this breakout schematic, this is how they are connected. However, in Arduino Diecimila schematic, they are switched. We’ve implemented the FT232RL in a board of ours, and used the pinout suggested by the datasheet, but this seems reversed. When we send a character to our board, the TX LED lights up, suggesting an incorrect datasheet, and a correct hook-up would be that of the Arduino Diecimila (labeled GPIO1 and GPIO0 instead of CBUS0 and CBUS1, respectively). This breakout board’s TX and RX LEDs function properly?
News - Organization chart! | about 2 years ago
I especially like the Administration/Shipping section. “So, when we’re not adminstrating, we’re packin' stuff” haha