Home | Member Profile

Product WIG-08627 | about 2 years ago

Hey for those who are interested in getting more out of this board, I’ve added multitasking to it. This allows running custom user code in parallel with the sampling tasks. So you could use the logomatic to command IOs, serial and/or SPI enabled devices, while the sampling is still happening, on the same processor.
Source code and articles available here:
https://sites.google.com/site/logodynamite/project-updates/agenericcbasedframeworkforrealtimemultitaskingembeddedsystems-part2

Tutorial - Snake Stomp Pads Design and Assembly Tutorial | about 2 years ago

ARMinator: How much does it cost to get one of these pads using ponoko?
Argh, just find out by reading the post in full!

Product SEN-08959 | about 2 years ago

A 100Hz or lower low pass RC filter works very well. I’ve also implemented digital filters with these and it works great too.

News - Dear ON Semiconductor | about 2 years ago

Alright, was just wondering

Tutorial - Snake Stomp Pads Design and Assembly Tutorial | about 2 years ago

How much does it cost to get one of these pads using ponoko?

News - Dear ON Semiconductor | about 2 years ago

Aren’t you infringing or helping infringe copyrights by displaying the inners of that chip?

Product SEN-08959 | about 2 years ago

Has anybody hooked up a scope to the output of this sensor? I have 2 here and I have to say the output on these units is extremely noisy. There’s a 1KHz clock that shows up in the output, at a fairly high amplitude.

Product WIG-08627 | about 2 years ago

For those interested, here is how to add a command prompt to the serial port of the logomatic board:
http://sites.google.com/site/logodynamite/project-updates/accessinganembeddedsymboltableprogrammatically
For now this implementation is blocking, that is you can only run either the logomatic logger or the command prompt. The command prompt is handy for debugging and/or launching/stopping measurement on demand.

Product WIG-08627 | about 2 years ago

What compiler and IDE is being used with the firmware? Could SF release some kind of information on how they built and configured the toolchain? As well, could you explain how you integrated the bootloader to the toolchain?
Since SF recommends developing your own firmware, I believe this would be very valuable information to share (if not already done-could not find any ;) ).

Product PRT-00136 | about 2 years ago

Hum how confusing.
So now, which datasheet is supposed to go with the part? The one provided by Levi or the one provided by SF?
How about the SF library, is it now updated with whatever part is sold by SF?