Track My Order
Frequently Asked Questions
International Shipping Info
Send Email
**Replacement:** None. We are no longer carrying this LED breakout in our catalog. This page is for reference only. This is …
The RPI-1031 tilt sensor is capable of sensing a change in orientation in four different directions: forward, back, left or r…
**Replacement:**[BOB-12035](https://www.sparkfun.com/products/12035). We have a new rev of this breakout, go check it out! Th…
The EasyPoint™ N35P112 is a hall-effect based miniature joystick module. The integrated two-dimensional linear encoder moni…
**Replacement:** None. We are no longer carrying this breakout board in our catalog. This page is for reference only. This i…
**Replacement:**[BOB-10179](http://www.sparkfun.com/products/10179). We now carry this in the even brighter "general purpose …
Simple breakout board for the USB Female Type B Vertical Connector. We primarily designed this board so that you could panel …
This is a breakout board for the DS1077 is a dual-output, programmable, oscillator. Contains a filter capacitor and all 8 pin…
This breakout board gives you access to the little tiny pins on the ribbon connector for the, also tiny, GP-2106 GPS module. …
**Replacement:** None. We are no longer carrying this board. This page is for reference only. Slim breakout board for Compac…
This is a simple board that no one really needs but it sure comes in handy. If you've ever tried to hook up an FTDI to someth…
**Replacement:** None. We are no longer carrying this PCB in our catalog. This page is for reference only. This breakout boa…
Here is a breakout board for the LS20126 GPS receiver. The board allows you to access all the pins on the GPS module through …
This is a breakout board for the CC3000 WiFi Module. The CC3000 from TI (Texas Instruments) is a self-contained wireless netw…
Are you low on I/O? No problem! The SX1509 can leverage your I2C interface for 16 extra channels of GPIO. And that's not all!…
A simple breakout PCB for the CNZ1120 Photo Interrupter. This PCB has three connections for PWR (3V-6V), GND, and Signal. Whe…
**Replacement:** None. We are no longer rolling this board. This page is for reference only. The VS1103b is a single-chip MI…
**Replacement:** None. We only had a limited number of these left and now they are gone. It is now time for them to step out …
**Replacement:**[BOB-10608](http://www.sparkfun.com/products/10608). The new revision fixes the issue noted below. This page …
**Replacement:** None. There is no direct replacement. This page is for reference only. This is a simple breakout board for …
**Replacement:**[BOB-10653](http://www.sparkfun.com/products/10653). We've added an on-board microphone and output speaker ja…
This is the CP2102 Breakout Board. This is a great little tool for embedded systems that require a serial connection to a com…
Basic breakout board for FTDI's popular USB to UART IC. Now with internal oscillator and EEPROM, the FT232RL is an impressive…
**Replacement:** None. We do not currently have a replacement for this breakout but a revision is in the works. This page is …
**Replacement:** None. The ADH8066 module is no longer being produced so we are no longer carrying this breakout board in our…
**Replacement:** None. The IC is obsolete and we've yet to spin a board for the suggested replacement. This page is for refer…
**Replacement:** None. We have retired this product. This page is for reference only. This new version fixes the pinout for …
**Replacement**: [BOB-09822](http://www.sparkfun.com/commerce/product_info.php?products_id=9822). This board has been replace…
**Replacement:**[BOB-11978](https://www.sparkfun.com/products/11978). We've released a new rev of this Logic Level Converter …
[Weather-band radio](https://en.wikipedia.org/wiki/Weather_radio) is an awesome service on the 162.4 to 162.55MHz band in the…
**Replacement: **None. We are no longer building this breakout board. This page is for reference only. This is a breakout bo…
**Replacement:**[BOB-11722](https://www.sparkfun.com/products/11722). The new rev for this board incorporates RGB, go check i…
**Replacement:** None. We are no longer carrying this breakout in our catalog. This page is for reference only. **Descriptio…
This breakout board gives you a pretty slick interface for rotary input. Since rotary encoders turn continuously it can be di…
**Replacement: **[BOB-09966](http://www.sparkfun.com/commerce/product_info.php?products_id=9966). The new version breaks out …
The VS1011 is a great MP3 decoder, and with this breakout board, it's easy to drop it into any project. The VS1011 is capable…
**Replacement:**[BOB-11403](https://www.sparkfun.com/products/11403). We've revised this board to fit a new SD card socket, i…
**Replacement:** None. There is no direct replacement for this item. This page is for reference only. The 'mini-Bully' is a …
**Replacement:** None. It's time for this item to step down and make room in the catalog for [more cool parts](https://www.sp…
**Replacement:**[PRT-10588](http://www.sparkfun.com/products/10588). The new revision corrects the board layout so that the s…
**Replacement: **None. We have retired this product. This page is for reference only. Small breakout board for the Crystal L…
This is a breakout board for the built in WS2812 RGB LED. The WS2812 is actually an RGB LED with a WS2811 built right into th…
**Replacement:**[BOB-10496](http://www.sparkfun.com/products/10496). This board had errors with the pinout of the connector. …
This is a simple breakout board for the screen keys. Comes with 1k pullup on the Button pin.
**Replacement:** None. We don't carry a direct replacement for this board, but have a look at our [development tools](http://…
