Stepoko: Powered by grbl Hookup Guide

Contributors: MTaylor

Cutting and Engraving a SparkFun Coaster

Squares are alright, and it's fun to watch the machine move around, but eventually you'll want to actually cut some real shape out with the mill. I've put this Shapoko Coaster Project together to show all the steps of cutting a project with a mill.

This uses open source software for all steps:

• Create design in inkscape
• Create took paths through makercam.com
• Send gcode with Universal Gcode Sender
• Stepoko runs grbl on the mill

Watch a video of the coaster being made below: