- Home
- Product Categories
- Battery
- Coin Cell Battery Holder - 20mm (SMD)
Coin Cell Battery Holder - 20mm (SMD)
Now for all of your coin cell battery surface mount needs, the 20mm SMD Coin Cell Holder. This holder fits our 20mm Lithium Ion coin cell battery and holds the battery in place with friction. The metal housing connects to the positive (+) side of the battery and the PCB pad underneath is connected to the negative (-) side.
Coin Cell Battery Holder - 20mm (SMD) Product Help and Resources
Core Skill: Soldering
This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.
Skill Level: Competent - You will encounter surface mount components and basic SMD soldering techniques are required.
See all skill levels
Comments
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Customer Reviews
5 out of 5
Based on 1 ratings:
Good for bottom of Artemis RedBoard/ATP
It fits the pads on the bottom so you can run the whole board off either a regular CR2032 lithium primary, or a rechargeable 2032 battery.
Sure wish you stocked a switched version. Seems the only coin cell battery holder with a switch on the site are the sewable Lilypad versions.
Perhaps they could add it to a future revision of Coin Cell Battery Holder Breakout - 24.5mm (PTH) :)