Shopping Cart 0 items
log in register
Today's Deals Forum Desktop Site
All Categories
Featured
Brands
Development
Sensors
Tools
Miscellaneous
Components
E-Textiles
Robotics
Wireless & IoT
Audio

Creative Commons images are CC BY 2.0

Favorited Favorite 1
Wish List

ProtoBoard - Round 2"

This is a very simple but extremely handy, 2" round, double sided perf board. Standard 0.1" spacing with a 4-40 (3mm) holes for mounting.

Note: Color may vary.

ProtoBoard - Round 2" Product Help and Resources

Core Skill: Soldering

This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.

1 Soldering

Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels

Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • WayneO / about 11 years ago / 1

    Easiest way is to use 30ga wire .... just lay it along side of the component lead and solder it to the pad... If the desired connection is an adjacent pad, then just use bare 30ga wire... else use insulated wire (wire-wrap wire)

  • ow3n / about 13 years ago / 1

    Would be great if I could download the relevant file to mockup in Fritzing.

  • lukec / about 13 years ago / 1

    Does anyone know of you could fit an ATmega, two h-bridges, two motors and two sensors on this thing? That would be fun.

  • ow3n / about 14 years ago / 1

    What is the best way to make connections between components on a board like this?

    • WayneO / about 11 years ago / 1

      Easiest way is to use 30ga wire …. just lay it along side of the component lead and solder it to the pad… If the desired connection is an adjacent pad, then just use bare 30ga wire… else use insulated wire (wire-wrap wire)

    • Murraybot / about 14 years ago / 1

      Agreed they state no trace. My idea is for just a silacone board with plated through holes that aren't traced to anyother hole, in which i could just lay a line of solder from hole to hole, maximizing effecency. Perhaps this board is built like that but I can't tell from the pics.

Customer Reviews

No reviews yet.