- Home
- Product Categories
- Accessories
- JST SH Jumper 6 Wire - 1 Foot (EM-401 and EM-406)
JST SH Jumper 6 Wire - 1 Foot (EM-401 and EM-406)
This is a 1 foot long JST SH communication cable which can be cut and hacked to your needs. Ideal if you have a UAV project where the GPS module may be a distance away from the controller board. Cable has two 6-pin JST connectors with 1mm pitch. Wired pin 1 to pin 1.
JST SH Jumper 6 Wire - 1 Foot (EM-401 and EM-406) Product Help and Resources
Alphanumeric GPS Wall Clock
January 26, 2015
This is a GPS controlled clock - a clock you truly never have to set! Using GPS and some formulas, we figure out what day of the week and if we are in or out of daylight savings time.
GPS Basics
December 14, 2012
The Global Positioning System (GPS) is an engineering marvel that we all have access to for a relatively low cost and no subscription fee. With the correct hardware and minimal effort, you can determine your position and time almost anywhere on the globe.
Comments
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Customer Reviews
No reviews yet.
Is there a similar wire like this but just with 4 pins instead of 6?
Like our Qwiic cables?
Is this male on one side & female on the other? In other words, can one end plug into the other? I want to cut it and use it to add quick-connect ability to a project.
I need a connector like that one above but I'm not sure about the pitch. Someone could help me?
The FC I'm using is this one, http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=74669
and the GPS I need to connect is this one:
http://www.hobbyking.com/hobbyking/store/__74664__Micro_HKPilot_GPS_And_Compass_u_Blox_NEO_6_and_HMC5883_EU_Warehouse_.html
how about a breakout board that does nothing other than expose the pins on a breadboard ready header?
I agree, the breakout board below does not route pin to pin and is wrong for some of the GPSs
I am new to this. I need the GPS unit and an extension cable. Thank you for your help.
This and the corresponding GPS module below (465) should work.
Sweet!! It would be nice if you offered an 8 pin version for the FV-M8 (formerly the EB-85A) that was 1 foot long. Those tiny pins are tough to deal with!