Dr. Molt
Member Since: September 26, 2017
Country: United States
-
My apologies, I was looking at the wrong bit. Turns out the enable bit is a perfectly good bit to use to determine whether the Si4703 is powered up or down.
-
Any suggestions on how to determine the current power state?
The enabled bit resets to 0 after power up, and the disabled bit resets to 0 after power down.
-
Per my understanding, no, you should not connect it to 5V.
-
Yes, 995 would be used to tun to 99.5.
-
What can be done to eliminate the popping sound when enabled?
No public wish lists :(