Member #140000
Member Since: June 27, 2010
Country: United States
-
Can I connect this shield with the ESP8266 (i.e. Feather HUZZAH ESP8266)?
-
Can I use secondary barrel jack to charge the battery using USB power? Can I do this parallel with solar charging?
-
You can control the intensity by changing the voltage between the positive and negative pins of the vibe motor. Just connect the vibe board to a analog pin and GND. Use following code. analogWrite(vibe, val); Replace val with 0-255. See the data sheet for Vmin for determine the minimum value for val. Hope this help you.
-
Can I use this for power up an Arduino UNO?
-
This is because of the following issues: 1. loose connection of the 10k trim pot resistor. 2. 0k. Adjust the trim pot resistor to higher value.
No public wish lists :(