Creative Commons images are CC BY-NC-SA 3.0

Retired RETIRED

This product has been retired from our catalog and is no longer for sale.

This page is made available for those looking for datasheets and the simply curious. Please refer to the description to see if a replacement part is available.

Replacement: None. We are no longer carrying this board but you can check out our development tools category for more development and prototyping boards. This page is for reference only.

Description: Prototype board for 14 pin PIC microcontrollers with power supply circuit, crystal oscillator circuit, RS232 port, ICSP/ICD port.

  • FR-4, 1.5 mm (0.062"), green solder mask, white silkscreen component print
  • Four mounting holes
  • Power plug-in jack
  • ICSP/ICD connector for programming with PIC Programmers and Debuggers (for PICs with ICD support)
  • Voltage regulator +5V, 78L05 and filtering capacitors
  • LED to RC2 through jumper
  • Quartz crystal oscillator circuit - 20Mhz
  • DIL14 microcontroller socket
  • RS232 DB9 female connector
  • RS232 MAX232 interface circuit with Tx, Rx, CTS, DTR/RTS signals
  • Extension slot on every uC pin
  • Grid 100 mils
  • GND bus
  • Vcc bus

Documents:

Dimensions: 100x80mm (3.9"x3.15")

Board does not come with PIC installed. Please see a list of related ICs below.

Comments 1 comment

  • What’s the recommended compiler and programmer software for this dev board? I haven’t had success with my Pickit 1 and 16F688, it is always “Checksum verify failed” on Classic Flasher 1.31, with a HEX produced by Oshonsoft Basic. I haven’t tried flashing from within the Microchip IDE yet because the included ASM and C samples have a degree of difficulty to port from chip to chip.
    Hopefully the compiler and programmer for this board are Linux based.


Related Products