×

Due to the impacts of the coronavirus outbreak, we are experiencing longer than normal lead times on certain products. We encourage back-ordering out-of-stock items to receive them as soon as possible.

18 Pin PIC Development Board

Replacement: None. It's time for this product to step aside and make room in the catalog for even more cool stuff. This page is for reference only.

Prototype board for 18 pin PIC microcontrollers with power supply circuit, 20MHz crystal oscillator circuit, RS232 port, and ICSP/ICD programming port.

  • FR-4, 1.5 mm (0.062"), green solder mask, white silkscreen component print
  • Four mounting holes - diameter 0.13" (3.3 mm)
  • ICSP/ICD connector for programming with PIC-PG1, PIC-PG2C, and debugging with PIC-ICD1 (for the PICs with ICD support) or PIC-ICD2
  • Power barrel jack
  • Voltage regulator +5V, 7805 and filtering capacitors
  • LED to RB3 through jumper
  • Crystal oscillator circuit 20Mhz
  • DIL18 microcontroller socket
  • RS232 DB9 female connector
  • RS232 MAX232 interface circuit with Tx, Rx, CTS, DTR/RTS signals
  • Extension slot on every uC pin
  • Grid 100 mils
  • GND bus
  • Vcc bus

Board does not come with PIC installed. Please see a list of related ICs below.

  • 3.9x3.15" (100x80mm)

Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Just to clarify: use this board with 18-pin PIC16's, not PIC18. The latter will end up connecting the USART RX pin to the ICD PGM pin TX to the LED, while leaving its PGM pin floating. Jumpering pins 10 and 11 for PIC18 works to obtain ICD connectivity, but there is no RS-232E functionality without cutting a few traces and rerouting the LED.

Customer Reviews

No reviews yet.