Creative Commons images are CC BY-NC-SA 3.0

Retired RETIRED

This product has been retired from our catalog and is no longer for sale.

This page is made available for those looking for datasheets and the simply curious. Please refer to the description to see if a replacement part is available.

Replacement: None. There is no direct replacement for this board. This page is for reference only.

Description: Prototype board for the LPC2106 processor.

  • MCU: 16/32 bit LPC2106
  • 128K Bytes Program Flash, 64K Bytes RAM, RTC, 2x UARTs, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
  • 14.7456 MHz crystal divides down for easy communication setup
  • Internal 4x PLL = 58.9824 MHz CPU clock
  • JTAG connector as per ARM's 2x10 pin layout, ARM-JTAG (Wiggler) compatible
  • RS232 interface circuit
  • RESET circuit
  • Push BUTTON with pull-up resistor
  • Status LED
  • Boot loader enable jumper and pull-up
  • DBGSEL, RTCK pull-up resistors
  • Two on board voltage regulators rated up to 800mA - 1.8V (Internal CPU) and 3.3V (General I/O)
  • Prototype PCB area with +3.3V and GND bus
  • Extension header for uC pins
  • DC power jack - Center positive
  • Single power supply: +5-9VDC required
  • Power supply decoupling/filter capacitors
  • PCB: FR-4, 1.5 mm (0.062"), green solder mask, white silkscreen component print
  • Four mounting holes

Dimensions: 3.9x3.05" (100x77mm)

Documents: LPC-H40 Schematic

Comments 1 comment

  • Great board, very flexable! most recommended to any one who is wishing to start up with ARM. have a visit to the LPC2000 yaho groups board and read through the tutorials
    have fun


Related Products