Replacement: None. There is no direct replacement for this board. This page is for reference only.

Prototyping board for the MAX2000-RAX processor.

• MCU: MAX2000-RAX up to 20MHz/20MIPS, low power 190 uA @ 8Mhz, power supply 1.8-2.5V, 16 bit microcontroller with 64 KB Flash, 2KB RAM, 3x 16bit Timers, 2x UART, 1x SPI, 1-wire, build-in driver for 132 segment LCD
• JTAG connector
• 20MHz socketed crystal
• 32.768 kHz RTC crystal
• 2x RS232 connectors, one can be used for code bootloader
• 1x SPI port on connector
• 1-wire connector
• Buzzer
• Lithium Coin cell 3V battery holder (no RS232 power supply when using this battery)
• Two buttons on ports with interrupts
• RESET button
• Status LED
• Power supply LED
• Two on-board power supply voltage regulators supplying +2.5V to core and +3.3V to GPIOs
• PWR_JTAG allow board to be power supplied by the JTAG (if MAXQ-JTAG-USB is used)
• Power supply filtering capacitors
• Extension headers for each uC pin on 0.1" row header
• Prototype area with GND and 3.3V bus
• Power jack connector for AC/DC power supply
• PCB: FR-4, 1.5 mm (0,062"), red soldermask, white silkscreen component print

Software:

• Sample C demo code for IAR EW for MAXQ for Buttons, Buzzer, UART, LED blink etc. here
• Sample C demo code for CrossWorks for MAXQ
• Sample assembler demo code for MAXQ-IDE

• 3.93x3.14" (100x80mm)

• Available for download at MAXQ-FORUM file area
• Schematic of MAXQ-P2000
• MAXQ JTAG connector (TOP view)