×

Doing some holiday shopping? Please check here for shipping deadlines to make sure your order arrives in time.

Motion Detection Module - MSP430F2013

Replacement: None. We are no longer carrying this part. This page is for reference only.

Small motion detection board using the MSP430F2013.

  • MSP430F2013 microcontroller
  • Low power PIR sensor
  • Status LEDs
  • CR2032 battery holder
  • JTAG connector
  • Supports both Olimex and TI SBW layout
  • 42x26mm (1.6x1.0")

Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

  • Blake B / about 13 years ago / 1

    I apologize if this is a silly comment, but I am looking for a motion detector for an Arduino based build. Does anyone know if this can interface with the Atmega or another solution?

    • Blake B / about 13 years ago / 1

      A stupid question it was indeed actually. My god. Just noticed the same sensor (without the board and Microcontroller) in the related products at the bottom of this page.
      =)

  • Dan123 / about 13 years ago / 1

    I have used the 2013 and i doubt it will work with that JTAG programmer.
    You can buy the ez430-f2013 for $20. Be sure to get something to interface the connections as the header on the ez430 won't fit the above .

  • Jumper / about 13 years ago / 1

    Will this JTAG programmer, http://www.sparkfun.com/commerce/product_info.php?products_id=15 , work on this motion board given that the programmer doesn't support SBW? This will be my first step out from Arduino and I'm not keen to drop 70$+ on a programmer. I also would appreciate any advice on what I need to make this work, and whether or not it's reasonable for a newbie to learn it. Or if I'll desperately need SBW even for a simple application.

Customer Reviews

No reviews yet.