Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
Member Since: January 1, 2010
Country: United States
Hmm I stand corrected
I was wrong :(
If it fully ran to empty would you then have to reset the voltage you want though? Thanks for replying
Is there any way to permanently set the voltage out, aka jump a connection? Or does the sole button on top cycle through the different options?
Is there any word on replacement handles?
I just use a mosfet as a low side switch and it seemed to work fine, it inverts the logic but you can deal with that however you want. Please correct me if Im wrong anyone.
This may be a dumb question but Im assuming SYS OUT puts out 3.7v Would that be correct?
Im thinking would it be possible to replace the Z0103MN triacs with the Z0103NN to handel up to 800v?
Would it be possible to run cold cathode tubes off this board? It looks like standard 12" computer case tubes come with 680v inverters which looks to be just over the voltage that the triacs can handel. Did I just awnser my own question?
Any help would be appreaciated thanks
Can you auto reset wirelessly with this device? I dont see a dtr pin :S
Sorry if this is a dumb question
No public wish lists :(