Dragon2

Member Since: January 2, 2010

Country: United States

  • Product COM-09831 | about 4 years ago

    WOW that would be an awesome idea

  • Product COM-00527 | about 4 years ago

    No the input voltage must be 1.5v higher then the output voltage therefore you would not get 9 volts with a 9 volt battery the most you would get is 7.5 volts. Also if you wanted 9 volts from a wall wart you would need a 10.5 volt one but a 12 volt would be the best

  • Product BOB-00204 | about 4 years ago

    Can anyone point me in the right direction to use this with an arduino thanks

  • Product COM-09622 | about 4 years ago

    could you link to an inverter that i could use?? thanks

  • Product SEN-08880 | about 4 years ago

    So for everyone wondering if it is supposed to get hot I just realized that “H” Pins stand for heat or heater so yes it is supposed to get warm in order for it to work

  • Product BOB-08891 | about 4 years ago

    Could definitely use a schematic of this breakout board in use. I tried a lot of diff possible ways and while I got one to show me something in the serial output the sensor was getting hot and I am sure that is wrong.

No public wish lists :(