60400

Member Since: January 5, 2010

Country: United States

  • Product DEV-08957 | about 4 years ago

    I was reading the setup instructions at http://funnel.cc/Hardware/FIO?userlang=en and at the end of the page it says we have to solder a jumper on the FIO board and another one on the XBee Xplorer USB board. Why is that?
    Will it make the XBee Xplorer only work with the FIO if I do that? Would it work without soldering these jumpers, I mean… is it necessary?
    There’s not much explanation in the funnel website and I would like to know what is that for.
    Thanks!

No public wish lists :(