×
Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
MakingTech
Member Since: January 6, 2010
Country: United States
-
What is the pin mapping to use analog pins as digital outputs on the ProMicro? For instance on an a ATmega8/168/328-Arduino, analog pin 0 can be addressed as digital pin 14, and A1 as D15 etc.
-
is there any reason I couldn't use an ISP to program this with the Arduin IDE?
Or even load a boot loader (using an ISP), break off the reset pin, and program it with a serial port just like any other Arduino?
This board is exactly what I am looking for but I have a codebase in Arduino. I don't see any reason to move it all over to WinAVR If I could just turn this little guy into an Arduino.
No public wish lists :(