Member Since: January 6, 2010

Country: Australia

  • Product SEN-10341 | about 3 years ago

    Lower your home power use! :-)

  • Product COM-00306 | about 3 years ago

    I’m using this with an Arduino. With a multimeter, the voltage on the output pin looks fine (0.33V in my kitchen - it’s hot here at the moment), but when I connect it to the Analog Input on the Arduino, the voltage jumps up to around 1.1 volt!? Any ideas why this might be?

  • Product CEL-09607 | about 3 years ago

    Hey ddean, did you ever get anywhere with this? I was hoping to do the same thing but not having any luck…

  • Product CEL-10138 | about 3 years ago

    Good question though - obviously it requires an antenna, but it seems sparkfun do not sell interface cables to plug it into a normal SMA antenna? Anyone know where to get these?

No public wish lists :(