Anyone

Member Since: January 6, 2010

Country: United States

  • Tutorial - Beginning Embedded Electronics - 9 | about 4 years ago

    I figured out what happened - this is rather important and was not mentioned anywhere.
    I closed down eagle then when I found that the example was not finished I opened the schematic only, created v1.1 by performing a “save as” and started the edit. This caused the synchronizing of the schematic and layout to be lost. Once the layout has been created you must always open it with the schematic and be the same naming. then the schematic edits show up automatically in the layout.
    See topic “Forward & Back Annotation” in Eagle help.

  • Tutorial - Beginning Embedded Electronics - 9 | about 4 years ago

    I agree, there are a couple places in this tutorial where you have to figure out what to do.
    Example - on this last step of adding the forgotten ground, you add it to the schematic then save to V1.1; how do you add it to the layout without starting over?

No public wish lists :(