×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #1116485

Member Since: August 28, 2017

Country: United States

  • SOLUTION (for me at least)

    I had a similar issue where the sensor would sometimes output humidity values over 100% (when I blew on it for example).

    In my case, it was solved by shorting the pullup resistor enable/disable pads with solder like in the pictures above (the blob between the two 472 SMD resistors). It didn't have this blob when I received it; there were three small, separate pads.

No public wish lists :(