×

SparkFun Electronics will be closed in observance of memorial day on Monday, May 29th. We will resume normal business hours on Tuesday, May 30th. Any orders placed after 2pm Mountain Time on Friday, May 26th will process and ship out on Tuesday, May 30th.

DWF

Member Since: January 12, 2010

Country: United States

  • I am trying to use two of these boards to make a 115200 baud wireless serial extension. I configure one end to make an adhoc network, and the other end to auto join to that network. It gets connected, but when it starts to stream bytes, it just chokes, and only sends partial data. I have tried loads of configuration settings, to no improvement. I contacted Roving Networks, and they advised added a soldered on wire between the radio can, and the ground point, which I did, but still it is not better. When I use the second module to ‘scan’, I get RSSI of -44, which is awesome, but still not getting a steady stream of data. My interrogation is to send a single ’m' character, every 0.5 seconds, and the receive side always sees that, but I only get small sections of the streaming response. Has anyone else every tried to use the modules in this way, and if so, what’s the magic?

  • Schematic only has sheet one of two. Please include sheet two also.

No public wish lists :(