RGFTech

Member Since: January 14, 2010

Country: United States

  • Product BOB-08745 | about 4 years ago

    There seems to be enough question around the subject, since the tool is used mostly for I2C and UART, how about a simple couple of schematics showing the I2C connection where the bi-directional lines must be used along with another showing a connection between two UARTS (on microprocessors) and finally between a 3.3v microcontroller and teh RS232 interface to a PC/USB?
    Can I assume that the board has to be viewed from the perspective of the low voltage side of the interface you are trying to make? So the TXI will hit the 3.3v TX pin while the TXO will hit the RX pin on the 5v device? Sorry for not being bright enough to figure that out on my own.

No public wish lists :(