Member Since: January 29, 2010

Country: United States

  • I’ve been having fun with this programming AtTiny13’s. Two problems – the schematic shows the top view of the cable plugs (cable side) not the bottom view (hole side) so if you’re looking at the holes you have to reverse everything. I used a continuity tester to determine the position of VCC on each connector and marked the position with a dab of nail polish, just so I wouldn’t forget. Also, I found it necessary to drop the -B 1 from the avrdude command line. I’m connecting through a secondary hub, and the extra delay was causing connection problems with -B 1 specified. Even without it, the whole process completes before you can release the enter key, so it isn’t really needed. I didn’t need to use the -F option.

No public wish lists :(