Member #117835

Member Since: January 30, 2010

Country: United States

Product BOB-09118 about 4 years ago

It would be great if this board were rotationally symmetric so that it could be used for inputs or outputs just by flipping the board around. You could leave the output/HV side as is and rearrange the input side as follows:

Pin 1 (currently the NC square pad) becomes GND, Pin 2 (currentyl IN1) becomes IN2, Pin 3 (currently IN2) is NC, Pin 4 (currently GND) is the new IN1.

This lines up the mappings with the output/HV side so if you rotate the board 180 degrees, the signals and grounds line up on the same pins.
Product WRL-12569 about 5 years ago

Has anyone tried to have more than one running in UDP broadcast mode? Any issues with packet collisions?

No public wish lists :(