Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
Member Since: February 2, 2010
Country: United States
Tutorial - Pi AVR Programmer HAT Hookup Guide about a year ago
This HAT is awesome! I may have missed this in the directions, but I had to run raspi-config and enable SPI. I'm somewhat of a Raspi noob, but figured it out. Maybe that is something new in Buster.?.
Also, a little bummed that you have to solder the target logic levels. Having those voltage pins sticking up off the board wouldn't be good. So, I see why it was done that way. Maybe just buy a separate HAT for each logic level.
Product COM-11272 about 8 years ago
Do you sell a 5 Meter version? Also, word of warning. I purchased the PRT-11182 pigtail and the wire colors did not match up. I used a small screwdriver to remove the pins/wires and arrange them to match the color coding on the attached connector. Glad I didn't let the magic smoke out...