pdp7

Member Since: February 6, 2010

Country: United States

  • Hooray for SparkFun Electronics deciding to sell the excellent LulzBot TAZ 4 3d printer. It is 100% Open Source Hardware and Respects Your Freedom certified by Free Software Foundation!

  • Hooray for SparkFun Electronics deciding to sell the excellent LulzBot TAZ 4 3d printer. It is 100% Open Source Hardware and Respects Your Freedom certified by Free Software Foundation!

  • Howdy - I built the kit last night, but it seems the pattern runs incorrectly.
    When I power it on, the yellow LED turns on solid and then it fades in and out sets the three sets of 3 LEDs (lasting about 2 secs for each group).
    However, then all the LEDs turn off for about 30 seconds (a seemingly long time).
    I’m guessing this is not the correct operation. One thought was that the internal clock is running slow for some reason but not sure how to verify and correct that.
    Anyone else have this problem?
    Thanks,
    Drew

No public wish lists :(