avatar

Kiko Lobo

Member Since: February 21, 2010

Country: United States

  • Can this be used to detect PH or Ammonia in water?

  • Where can I find the board specs (size, holes, etc) [Mechanical Drawings]

  • I am getting consistent off values. I get about 2 deg C on the cold side, and the pressure readings are off, even when using calibration formulas.

    I am unable to get accurate readings no matter how I calibrate it.

    Is this a design issue or an issue directly related to my Shield? If so.. How can I get it checked and exchanged for a good one?

    I’ve tried support contact, they where going to get back to me but never did…

    Thanks

  • Is there a link to the source code in the PIC chip? I want to implement this in an arduino.. Is it possible? Just need the position detection, not the potentiometer part.

No public wish lists :(