×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #1260282

Member Since: December 25, 2017

Country: United States

  • Hi all, I know this thread is a bit old but i have a Romeo Edison board by DFRobot and i was wondering how to get back to Yocto after installing Ubilinux. When i had Yocto - two serial ports appeared. Now only one appears permanently - the other only temporarily as the Ubilinux image boots up..

    I have an OTG and a COM micro USB port but as i said only one port not appears permanently (the cu / tty.usbserial-A387XXX78 etc port).

    i can ssh into ubilinux etc but i can't run any intel based dfu software nor can i run the 3.5 yocto image using the command ./flashall_mac.sh cause it does not find the serial port.

    Again the serial port does appear briefly as ubilinux boots up and a flash drive mounts and unmounts during the boot too.

    I need to go back to yocto as the Arduino IDE expects yocto to allow successful uploads to the Romeo Edison board.

    Cheers, Michael.

No public wish lists :(