avatar

Rowland

Member Since: April 24, 2010

Country: United States

Profile

Graduate Student @ Georgia Tech

  • Product GPS-10920 | about 2 years ago

    There was comment on the last revision of this board (GPS-09171) that VBAT would not be tied to 3.3V on the next revision (this one GPS-10920) but it still is. Also, the enable pin on the regulator should be broken out so that the GPS can be put into sleep mode. See page 12 of the datasheet.

    Does anyone have a recommendation on how to cut power to this board using an I/O pin from an Arduino?

  • Product RTL-09877 | about 3 years ago

    In the datasheet it says to set the splash screen send the special charter 124 followed by “j”. What is ? I haven’t been able to get this to work.

Name Pieces Total
QuickBot Parts
This list has the necessary parts needed for the QuickBo…
40 196.49