×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

VTNOAH

Member Since: April 25, 2010

Country: United States

  • Does anyone know if the RESETB pin is pulled high/low or just floats? I'm trying to create a switch to turn this chip on or off without any CMOS devices.

  • Hey guys! If you decided to make a breakout board for this chip could you isolate the signal lines on the PCB from the rest of the traces? The capacitance from signal to gnd on your other breakout MUX was too high for me to use and I think its because the signal and gnd traces are adjacent to each other throughout the board. Otherwise keep up the good work!!

No public wish lists :(