Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #133367

Member Since: May 10, 2010

Country: United States

  • Works fine. From windows 10, Arduino 1.8.8, if you get the following error during upload, it is likely that you're not using the correct programmer option. From the Arduino programming software, be sure to select, Be sure you select "Tools>Programmer>USBtinyISP". I didn't see this in the initial documentation and spent a few hours finding this nuance.

         Using Port                    : usb
         Using Programmer              : stk500v2

    An error occurred while uploading the sketch avrdude: usbdev_open(): did not find any USB device "usb" (0x03eb:0x2104)


  • I've got the 3-24-10 version of this shield and accidentally broke off the top of the Dline/uart switch. Which pins should I solder/jumper together to make the shield permanently in dline state?

No public wish lists :(