×

We are still shipping! However, order processing may take longer than usual and we cannot guarantee same day shipments due to staffing guidelines from the CDC. Please see all COVID-19 updates here. Thank you for your continued support.

Member #134393

Member Since: May 17, 2010

Country: United States

  • Just to let people know, the EM-406 breakout board cannot be used as is. It does work though if you plug the GPS into the breakout board but the pins on the breakout board should be hooked up TX->TX, RX->RX, GND->1PPS, 3.3V->GND, an LED ->5V. With the 3.3V to the ground pin it will heat up both the VCCand the VBATT on the GPS chip. This is how i got it to work. I am also experiencing that it does not retain the configuration after the power is removed. Too bad they did not use the prior version chip-set for the GS407.

No public wish lists :(