×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

.mark

Member Since: May 19, 2010

Country: United States

  • Product SEN-09587 | about 4 years ago

    Good operation in HW mode for the default range, nice low voltage operation. However, running some crude tests, the “extended” range (only available in serial mode) on these did not appear noticeably better than the default range (~3m). In addition, there was an issue with the delay setting in serial mode (or digital mode as an earlier poster referred to it). When the MD/RST pin is set for MD (using serial command “CM”) it stays active (low) for about 40 seconds ignoring my delay setting of two seconds (serial command “D2”).

No public wish lists :(