Member Since: May 30, 2010

Country: United States

  • I am considering buying the Razor IMU and am new to electronics and programming.
    Which components are necessary to program the sensors on the Razor IMU? Are the FTDI basic breakout board + cable the only additional components needed? Do I need to purchase a separate programmer board? What software will I need to download to accomplish this? I’m unfamiliar with Arduino products, etc., so specific information would be greatly appreciated.
    My plan is to first solder the Razor to the FTDI basic breakout board, do the sensor programming, then desolder and connect the Razor to the Logomatic for several measurement events.
    Thanks a lot for your help!

No public wish lists :(