snowshoe

Member Since: June 22, 2010

Country: United States

  • Product BOB-10179 | about 2 years ago

    The data sheet pulls up the LUXEON Rebel sheet. Which LED is on this board?

  • Product BOB-09655 | about 2 years ago

    I am making a few lamps to hang in the corners of my living room. Do these need an external heat sink, or is the breakout enough?

  • Product SEN-00252 | about 4 years ago

    This is my first time using an accelerometer…I’m having issues…I’m using the arduino hooked up this way…
    VCC,SLP - 3.3v
    GND, GS1, GS2 - GND
    x - analog 0
    y - analog 1
    z - analog 2
    The data that I am reading into the serial monitor is all over the place, even when I’m not moving the accelerometer….when I try doing noise reduction by averaging rapid readings…i get a pretty steady 460-500 for all axis, moving or not. any ideas?

No public wish lists :(