Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
Member Since: June 29, 2010
Country: United States
Product SEN-08678 about 9 years ago
i bought one of these a while back, and am hooking it up to an arduino. i read through the comments and as suggested i have
pin 1 >1k resistor > +5v pin 2 >1k resistor > analog 0 pin 3 > ground
as i read the sensor, the output starts at around 500, and slowly sinks to zero over the course of 30 seconds, and when i tap any location of the potentiometer, the reading jumps to 1023 and declines at the same rate to zero. any clue what I've done wrong? could it be burned out? it recognizes presses, just not positional readings...
No public wish lists :(