Wehrdo

Member Since: July 3, 2010

Country: United States

  • Product DEV-09905 | about 4 years ago

    I ordered another 10 flexible jumpers, and I’m glad I did, because I’ve used almost all 20 before.
    Like the previous comment said, the button doesn’t fit perfectly, but I get it to stay with a bit of easing. The potentiometer has the same problem as the button. On the potentiometer I had to clip off the metal anchors to fit on the breadboard better.
    I wish in the description it would point to the exact LED’s that are sent in the kit so it wouldn’t take a lot of time to find the current and voltage draw for them.
    The Tri-Color LED is a great part in this kit. I’ve had lots of fun with it. But since the red pin has a lower voltage draw, I think the kit should should include some resistors to accommodate for that fact.
    I haven’t used any of the sensors in an actual application, but I’ve played around with all of them, and they seem to work fine.
    The arduino software & drivers installed perfectly. All the parts work great; definitely top notch. The board works just like it should too.
    Definitely a great starter kit if you’re just getting into this stuff.

No public wish lists :(