Member #142301

Member Since: July 13, 2010

Country: United States

  • Product DEV-11190 | about 7 months ago

    Hi Is there an error in the schematic for this board? It shows UVCC not connected to anything and UCAP connected to 3.3v. Is this correct? Jon

  • Product BOB-10616 | about 2 years ago

    Recently bought a few of these and the quality control was terrible. The soldering on the boards was very dry and i think some of the joints were intermittent. I had a look through a microscope and it was most noticeable on the TLC5940 and the resistors. It must have been a bad batch. JH

  • News - The CrazyFlie | about 3 years ago

    The only change I would make would be to have the arms as separate PCB’s. It think it would decrease the cost of the kit and also make it easy to fix when they break.
    JH

No public wish lists :(