Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.
Track My Order
Frequently Asked Questions
International Shipping Info
Mon-Fri, 9am to 12pm and
1pm to 5pm U.S. Mountain Time:
September 26, 2018
News - DIY 3D-Printed Lithophane
about 2 years ago
I'm a little confused as to how you wanted this to turn out?
If you were aiming to print a picture from the 80's it looks good.
If you were trying to make a lithophane try printing the whole thing stood up!
Depending on how you get the stl file, as in from a website generator or you
import a jpeg and do it in Cura. some require you to print the lithophane stood
upright on the z axis, where Cura requires you to do it flat.
Also on the website, I think, you have to make the image positive.
and in Cura you have to set darker is higher when you import your jpeg.
Otherwise you get the negative effect you have here. Hope this helps!
No public wish lists :(