×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

kelvie

Member Since: August 25, 2010

Country: United States

  • I just bought the logomatic to log serial data. Normally I would set the baud rate at 57600 8-N-1. In Hyperterminal, I wld get the correct ACSII data. On the Logomatic, I hv connected the same connections to the GND and RXI0 set it to use automatic UART, BAUD=57600. I think the logging is working, but the contents are gibberish characters. I have tried all the baud rates to no avail. Any ideas, anyone? Thanks!

No public wish lists :(