Due to some global internet issues outside of our control you may have issues accessing PayPal or using GitHub through our site. Please be patient and hopefully they’ll be up and functioning correctly soon!


Member Since: September 3, 2010

Country: United States

  • No status light when the EM408 is plugged in. I wonder if the board doesn’t hold and Enable/Disable at 3.3 V?

  • I too can not get the EM408 working on the eval board. I have been able to get it working on a bread board by hooking up the Rx input to Vcc with a 470 ohm resistor. Also connect Enable/Disable to Vcc. With baud set to 4800 I am able to record NEMA sentences. Still, would like to use it with the board. Any ideas?

No public wish lists :(