×

Prolonged severe weather across the U.S. is causing delays including the ability to transport and deliver packages in certain cities. Please see here for more details. Thank you for your continued support and patience.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

avatar

guillengap

Member Since: October 2, 2019

Country: Mexico

  • My QWICC connector doesn't communicate ... you can solder the pins GND, 3V3, SDA, SCL ... then connect them directly to the artemis board, Arduino UNO, etc and use the same libraries and examples of DOCUMENTS or: https://learn.sparkfun.com/tutorials/sparkfun-qwiic-micropressure-hookup-guide?_ga=2.85588889.1077246316.1611532025-1736339105.1600121553

  • RECOMMENDATION: I have one of these sensors and the Qwiic connector didn't work ... It only works with 12C pins (SDA and SCL) ... it's very precise and useful, and you just have to correct the Qwiic connector

No public wish lists :(