Member #155433

Member Since: October 9, 2010

Country: United States

  • Product WRL-09954 | about 2 years ago

    I think it is best to keep the cs high (for both devices) and only drive low when you need to access the device. At least for the wifly shield, each register read or write on the uart should have a toggle of the cs.

  • Product WRL-09954 | about 2 years ago

    This works great with my maple, would like to see pins brought out for status of association, connection, and command mode, as well as a pin to put it into command mode. Using the interrupt was difficult because you don’t know much about the state of the device. I am using it at spi of 4.5Mhz and uart at 921600 with hardware flow control, that seems pretty solid. Programming the uart seemed a bit tricky because of the way you need to access some of the registers, but it is nice to have the interface so you can burst out the incoming characters.

No public wish lists :(