avatar

marcio.camurati

Member Since: October 11, 2010

Country: Brazil

  • Hi, when I connect the Xbee to a Arduino Duemilanove with this explorer the tension at the DIN and DOUT is constant. If I connect at the 5v and monitor at the multimeter both show 4.46 and if I connect to the 3.3v at the multimeter show 3.24.

    Is it correct? I thought that the DIN and DOUT only had tension when use it, at my tests the LEDs never blink. The only led that blink is the RSSI when send a command to the Xbee.

    Update: I identified that if I detached the 5V PIN the energy continue (regulator power led on) while the RX is connected at the the Arduino, is this correct too?

    Best regards,

No public wish lists :(