Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #156405

Member Since: October 14, 2010

Country: United States

  • I don't think there are built in resistors, I connected +5V to the red diode anode and it was very bright for a very short time ;-) Then it was dead...

  • I assume that current limiting resistors are incorporated into the LEDs. I read the datasheet (not the best I've seen) but found no reference to these resistors. From the example sketch, it seems the LEDs are hooked up directly to the Arduino pins. --Thanks--

    As for the encoder, it works well...

No public wish lists :(