Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.


Member Since: October 26, 2010

Country: United States

  • I uploaded my solution to https://github.com/WilliamAltemus/HitCounterChallenge


    77 expected / 77 detected - 0% error

    81 expected / 82 detected - 1.23% error

    93 expected / 93 detected - 0% error

    79 expected / 78 detected - 1.27% error

    Mystery Dataset 1 - 169 detected

    Mystery Dataset 2 - 155 detected

    Thanks for the opportunity to participate in this challenge. It was a real learning experience!


  • I use a combination of this servo controller plus a couple xbees as a controller for my airplane and my quadcopter.

    Here is the program I wrote using Visual C# 2010 Express and the SlimDX SDK to pull data from a joystick, modify it, and send it out over a serial port.


    Here is a link to a thread I started about auto-resetting the controller after a fatal error. It also has a diagram of my airplane setup using only one battery to power everything.


  • Your .NET example link is broken. Here is a link to a simple servo control program I made using Visual C# 2010 Express.


  • I had the same problem where the device would not respond to anything I sent it.
    The data sheet says VLogic (VIO) voltage can be up to VDD. Wrong! You can't just tie them together.
    To solve this I made a small voltage divider circuit with two 10k resistors in series between 3.3V and ground. I connected VIO to the junction between the two resistors (3.3V/2 = 1.65V) and now the gyro works every time.

No public wish lists :(