×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

sdh7

Member Since: March 18, 2007

Country: United States

  • Product BOB-08953 | about 4 years ago

    I think I’ve figured out what may be a slight design flaw in this breakout board - I think DVDD should be exposed as a pin on the breakout board, which would make tying a signal to the GPIO pins much easier. To work around this, I’ve carefully soldered a wire to the via coming off of pin 32 (TEST on the VS1103, which is normally connected to the IOPWR, aka DVDD signal) onto my protoboard to act as a 3.3V rail…

No public wish lists :(