Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.


Member Since: December 26, 2010

Country: Australia

  • Definitely thru hole

  • You know I was really careful about heeding your advice. I used my Xbee pro to hold the headers in the right position then tacked them in place using only a small amount of solder. Unfortunately the solder still ran down the terminals and soldered the Xbee to the headers on one pin. With a little extra heat from the soldering iron and a small flat blade screwdriver I managed to remove the Xbee but still damaged it, not sure if it works yet. The other two boards I had to do I didn't push the Xbee so far into the sockets, the result, no problem. Lesson to be learnt, if you are going to use another part to space headers don't push it all the way in.

  • Smell this . . . Seems to have a fruity boquet . . . . I'm not sure about that. . . .

No public wish lists :(